Start your trial now! First week only $4.99!*arrow_forward*

Question

100 mol/min of butane is combusted with 60% excess air. What is the molar flow rate of air to the combustion chamber?

Tagged in

Engineering

Chemical Engineering

Find answers to questions asked by students like you.

Q: 1. Countercurrent multistage extraction. Pure methylisobutyl ketone (MIK) of 200kg/h is used to extr...

A: For counter current multistage flow pure methyl isobutyl is used to extract acetone

Q: Fuels for motor vehicles other than gasoline are being eyed because they generate lower levels of po...

A: Combustion reaction of propane with air is written as:Note that in the question CO2 and CO are given...

Q: In certain composition ranges of mixtures of ethylene tetrachloride (C2Cl4), isopropyl alcohol, and ...

A: Part (a)The basis of the calculation is taken as 100 lbs of feed mixture containing 40 mass% C2Cl4, ...

Q: 1:02 AM ll Verizon 99%- Done 4. The enthalpy of vaporization of water at 100 °C is 2256.9 kJ/Kg. Ass...

A: Watson equation is to be used as written below. Here, ΔH1 is enthalpy of vaporization at T1.ΔH2 is e...

Q: A liquid stream containing half n-hexane and half n-pentane at 80°C and 5 atm is fed at a rate of 10...

A: Part (a)The Antoine equation to be used is written below.Here, Pi* is the vapor pressure of the comp...

Q: The T-x-y and P-x-y diagrams for the binary benzene-toluene system is shown below. a. The bubble poi...

A: Part (c)The Antoine equation to be used is written below.Here, Pi* is the vapor pressure of the comp...

Q: This problem is (7.13) from a book "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: Note that the given expression for the intensive Gibbs energy in a binary mixture of A and B is corr...

Q: How much heat (in kJ/hr) is released/absorbed (specify which) if 100 mol/hr of liquid n-heptane is c...

A: The combustion reaction of n-heptane is:

Q: 40. A liquid mixture containing 30.0 mole% benzene (B), 25.0% toluene (T), and the balance xylene (X...

A: Part (a)The basis of the given process is taken as 100 mol/h of feed mixture.The process involves di...

Q: An open container is filled with water up to a depth of 3 meters and above water it is filled with o...

A: As per the given information, the tank is filled with oil and water as shown in Figure1.Density of O...

Q: *"24.27 In the vapor-recompression evaporator shown in Figure P24.27, the vapor produced on evaporat...

A: Part (a) The schematic flow diagram for the given process is shown below. Let the system be consider...

Q: A loaded semi-truck consumes about 10 US gallons of diesel per hour (assuming an average speed of 60...

A: 1 barrel of crude oil produces 10 US gallons of diesel. So, the amount of diesel produced by the giv...

Q: The surface temperature of the electronic chip shown below is 75C and it is surrounded by ambient a...

A: The area of the upper surface of the chip carrier is calculated as:

Q: Answer a - d. (a) What is the constant volume heat capacity (Cv) for HBr, assuming it is an ideal ga...

A: Dear student, we answer only threee questions in a thread. so, we are providing answers to the first...

Q: Please answer parts (d), (e), and (f).

A: Part (d)For the input, U(s) = 4/s, the output Y(s) is written as shown below.

Q: This problem is (6.10) from a book "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: Part (a): Given that the container is well insulated, N moles of a monoatomic ideal gas expands irre...

Q: This problem is (6.30) from a book "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: Hose is used for conveying water with the value of inside and outside diameter along with the given ...

Q: Energy conservation is important for houses. To what fraction is the heat transfer rate reduced by r...

A: For convective heat transfer through the glass window of area A ft2 having convective heat transfer ...

Q: The oxidative coupling of methane to form ethylene (2 CH4 + O2 -> C2H4 + 2 H2O) is known as the “...

A: Part (a)For an ideal gas,mole fraction = volume fractionFrom the given volume percent of the inlet g...

Q: April 2010, the worst oil spill ever recorded occurred when an explosion and fire on the Deepwater H...

A: Part (a)The formula to calculate the pressure on an object which is submerged in a fluid is:P = ρhgH...

Q: A rectangular steel (k = 58.7 W/m * K) fin 25 mm thick and 150 mm long is attached to a wall that is...

A: Part (a)The figure representing the given question is:Let the depth of the fin be 1m as the calculat...

Q: Formaldehyde is produced by catalytic oxidation of methanol by the following reaction: CH3OH + 1/2 O...

A: The basis of the process is taken as 100 mol CH3OH fed to the catalytic reactor.In the reactor, the ...

Q: The analysis of pesticides for environmental extracts using chromatography typically requires a solv...

A: Part (a).Let the basis of the process be 200 kg/min of the feed. Hexane is represented by ‘H’ and di...

Q: l Verizon 92% 11:26 PM Done Reynolds number a dimensionless number. It is defined as, Re = Where, p ...

A: Hello. Since second sub-part of your question does not provide the value of Reynolds number which is...

Q: .19 A liquid storage facility can be modeled by where y is the liquid level (m) and u is an inlet fl...

A: Part (a):Since all the derivatives are zero and y=u=0 at the nominal steady state, hence taking Lapl...

Q: Calculate the rate of heat loss by radiation from the upper surface of the electronic chip of Proble...

A: From the given data: TS = Surface temperature = 75⸰C = 348 KTsur = surrounding temperature = 25⸰C = ...

Q: A new engineering graduate was putin charge of a reactor. The engineer quickly learned that the proc...

A: Part (b)The Schematic diagram of the given process is drawn below. The basis of the calculation is t...

Q: Chemical and Bio-Process Control 4edSensor Systems:Consider flow sensor that reads 10,000 lb/h when...

A: Zero is the lowest value of the range in the measuring instrument and span is the difference between...

Q: .Verizon 89% 5:33 PM Done 2. A liquid system consisting of 5 % mole ethanol and the rest being water...

A: Part (a) At constant pressure, the temperature at which the liquid mixture boils is determined as sh...

Q: 1.19 A mixture of ethylbenzene (EB) and the three isomers (ortho, meta, and para) of xylene are wide...

A: Part (a):The normal boiling points of given components in mixture in their increasing order is given...

Q: A flash separator “flashes” (abrupt increase in temperature and pressure) a liquid stream containing...

A: The schematic flow diagram of the given process is shown below. n-hexane is represented by ‘1’ and n...

Q: PLEASE ANSWER B, C AND D. PLEASE ANSWER B, C AND D. PLEASE ANSWER B, C AND D.

A: The question has too many sub parts, we are only answering first three partsPart (a)For tank A,Mass ...

Q: 5.9 Two liquid storage systems are shown in Fig. E5.9. Each tank is 4 feet in diameter. For System I...

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question...

Q: A plastic (k = 0.5 W/m*K) pipe carries a coolant at –35C with a heat-transfer coefficient of 300 W/m...

A: Part (a)Inner radius of the pipe is, r1 = 3/2 cm = 1.5x102 mOuter radius of the pipe is, r2 = 4/2 cm...

Q: This problem is (8.10) from a book "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: For a system of variable composition (open system), the differential change in molar Gibbs free ener...

Q: A tank holds 100 gal of a water-salt solution in which 4.0 lb of salt is dissolved. Water runs into ...

A: Let the function for amount of salt (kg) in the tank at time ‘t’ minutes be, S(t).Now, the rate of c...

Q: Water at 20C with a mass flow rate of 1.0 kg/s enters an annulus formed by an inner pipe having an O...

A: Water is flowing at the rate of 1.0 kg/s in the annulus at the temperature 20°C. The inner pipe outs...

Q: For a test of enzyme-catalyzed kinetics, the following data were recorded product (mmol/mL) (mmol/mL...

A: Part (a)Michaelis-Menten equation to be used is written as equation (1).The reciprocal equation of (...

Q: Determine the kinetic energy in Btu/hr of 100 gallon/min of water flowing through a pipe with an ins...

A: The formula to calculate the kinetic energy of an object with constant mass in a rectilinear motion ...

Q: dy, dt dy, 4x2 = 4y1-6y2 + 21, + 4112 dt Find the four transfer functions relating the outputs (y, y...

A: Take the Laplace transform of the two given equations and label them as equation (1) and (2) respect...

Q: 4.4. A stream consisting of 44.6 mole% benzene and 55.4% toluene is fed at a constant rate to a proc...

A: Part (a)Let the molar flowrate of the fed stream be 100 mol/min. At the beginning, all the feed is l...

Q: The inner pipe of a double-pipe heat exchanger has an OD of 1.9 in. and contains 36 rectangular fins...

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question...

Q: Please show all steps, thank you

A: Part (a)Use the Lineweaver Burke plot to determine the value of Vmax (or rmax) and Km at 30°C and en...

Q: Please show all steps, thank you

A: AnswerPart a:Multiple stAnswerPart a:Multiple states are possible if enzymatic reaction is mass tran...

Q: 5.2. A friend suggests that the intensive pair (e,T) is enough information to determine the state of...

A: For a single phase, single component system, calculate the degree of freedom (F) from the Gibb’s pha...

Q: The oxidative coupling of methane to form ethylene (2 CH4 + O2 -> C2H4 + 2 H2O) is known as the “...

A: c) Density is defined as mass per unut volume. Thus, density of the inlet mixture may be determined ...

Q: 100 lbm/h of oil at 130F is needed for a process modification. The oil will be available at 70F, so ...

A: Oil is available at 70°F flowing at the rate of 130 lbm/h. It is required to heat the oil to 130°F. ...

Q: 5.9. Extraction of uranyl nitrate. A 20 wt% solution of uranyl nitrate (UN) in water is to be treate...

A: Dear student, we answer three parts in a question, so we are providing answers to the first three pa...

Q: 4.7 A single equilibrium stage in a distillation column is shown in Fig. E4.7. The model that descri...

A: Part (a)Assume that the molar holdup (H) of the given stage is constant and the molar overflow which...

Q: PLease show all steps

A: Part (a)Let the reaction taking place in the CSTR be, S→P According to the Michaelis-Menten equation...